Download AMS IFU format - AMS Labeling Reference Library
Transcript
Prosthesis Specifications Instructions for Use Compressed diameter Reference diameter 6mm 14mm Length at 14mm diameter: Product number 72401800 72401801 72401802 72401803 72401804 72401805 Length 1.5cm 2.0cm 2.5cm 3.0cm 3.5cm 4.0cm Caution: This device is to be used only by urologists who have received appropriate training regarding the use of the UroLume Prosthesis. Pre-operative Set-up The following materials are required for the placement procedure: • 12Fr, 0° to 12° telescope • Water flushing setup: typically 1 to 5 litres on I.V. pole, 5mm tubing • Urethral sounds up to 26Fr Delivery Instrument Specifications • UroLume Prosthesis kits (two of each size recommended) Diameter Outer shaft Retractable sheath Inner lumen Rounded collar 22.5Fr 21.0Fr 12.0Fr 24.0Fr Useable shaft length For 1.5cm prosthesis For 2.0cm prosthesis For 2.5cm prosthesis For 3.0cm prosthesis For 3.5cm prosthesis For 4.0cm prosthesis 20.7cm 20.7cm 19.5cm 18.5cm 20.5cm 20.5cm “A” Position ACMI (1.5-3.0 cm stents) Storz (1.5-3.0 cm stents) Wolf (1.5-3.0 cm stents) “B” Position ACMI (3.5-4.0 cm stents) Storz (3.5-4.0 cm stents) Wolf (3.5-4.0 cm stents) “C” Position Olympus (1.5-3.0cm stents) To place the prosthesis in the bulbar or prostatic urethra, these additional materials are required: • 17Fr cystoscope • AMS Urethral Measuring Catheter or a graduated ureteric catheter • Urethrotomy equipment (stricture only) Note: A selection of at least two UroLume kits in each size is advised. This inventory ensures that the correct size is available when the prostatic urethra is measured. Clinical investigators advise repeating the prostate measurement to ensure that an accurate measurement is obtained. Note: 12º telescopes cannot be used with a telescope stabiliser as they must be rotated to view the anterior bladder neck during prosthesis placement. Premedication Prior to implantation with the UroLume Prosthesis, patients should be given prophylactic broadspectrum antibiotic coverage according to the protocols commonly used by the hospital. Patient preparation Place the patient in a lithotomy position, prep with aseptic solution and drape. Figure 4a: Insert and remove the telescope from the scope stabilizer, by grasping the scope stabilizer as shown. 5