Download DUAL CONTROLLER DESCRIPTION

TECHNICAL INFORMATION
By pressing the CHANGE CONFIG button, the display will
show in sequence the current and pressure values of the
pump, and the pressure values of the Eyesys Gauges if
installed.
The three LEDs located underneath the LCD indicate the
operating mode that the controller is in.
NOTE
The following is displayed if an HV card is installed:
When H.V. is ON, it is not possible to change the Dual
controller’s operating mode.
H V 1
3
High Voltage Commands
If, for example, the controller has only one H.V. channel,
the following is displayed:
5
0
0
S C
/
T
r
5
0
0
S C
/
T
r
H V 2
3
0
0
S C
/
T
r
The voltage and pressure values will be displayed if only
one H.V. card is present.
The following is displayed if only one card is present:
2
.
5
7
0
E
-
9
0 0
T o
V o
r
l
-
9
-
6
T o
A m p
r
r
H V 1
6
.
5
E
-
6
A m p
H V 2
3
.
5
E
-
6
A m p
m G 1
6
.
0 E
-
7
T o
r
r
m G 2
3
.
6 E
-
9
T o
r
r
H V 1
3
.
7
E
-
9
T o
r
r
H V 2
3
.
9
E
-
8
T o
r
r
In a dual H.V. card and multigauge configuration, pressing
the CHANGE CONFIG button again displays the
multigauge pressure as indicated below.
If two cards are present, the display will only show the
values of the two voltages.
-
E
E
If two H.V. cards are installed the following are
displayed:
To switch-on the high voltage all the interlocks (cable,
Remote I/O connector and front panel) must first be
closed; then press the HV1 and/or HV2 buttons.
H V 1
0
5
If one H.V. card is installed (with multigauge option),
pressing the CHANGE CONFIG button again displays the
following:
If, for example, the controller has two H.V. channels, the
following is displayed:
H V 1
.
.
The following is displayed if two H.V. cards are
installed:
If after being powered on the Dual controller is set to the
LOCAL mode, the LCD will display a message concerning
the pump(s) selected.
H V 1
6
m G 1
3
.
8 E
-
8
T o
r
r
m G 2
5
.
6 E
-
9
T o
r
r
t
Pressing the CHANGE CONFIG button again returns to
the voltage value display.
r
The following is displayed if two cards are present:
H V 1
-
7
0
0 0
V o
l
t
H V 2
-
5
0
0 0
V o
l
t
The lighting of the LED located above the H.V. On/Off
button continuously informs the operator whether the high
voltage is present or not.
46/73
87-900-094-01 (H)