Download CDP-CX450

Getting Started
Unpacking
Check that you received the following items:
• Audio cord (1)
• Video cord (1)
• Monaural (2P) mini-plug cord (1) (Connecting cord
for CONTROL A1 ) (supplied for Canadian models
only)
• Remote commander (remote) (1)
• Size AA (LR6) batteries (3)
Hooking Up the System
Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
CONTROL A1
MONITOR OUT
DIGITAL OUT
(OPTICAL)
CD player
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert three size AA (LR6) batteries (supplied) by
matching the + and – ends on the batteries to the
diagram inside the battery compartment.
Insert the negative (–) end first, then push in and down
until the positive (+) end clicks into position.
When using the remote, point it at the remote sensor
on the player.
To an AC outlet
To line output (L)
To line output (R)
To audio input
z
Amplifier
When to replace batteries
If E flashes in the remote’s display, replace all the
batteries with new alkaline batteries. Use of battery types
other than alkaline batteries, such as manganese
batteries, may not last longer than the alkaline batteries.
The loaded memory in the remote will be retained for a
few minutes while you replace the batteries.
: Signal flow
To an AC outlet
What cords will I need?
Audio cord (supplied) (1)
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or leave
too near lighting apparatuses. Doing so may cause a
malfunction.
• If you do not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
4GB
White
(L)
Red
(R)
White
(L)
Red
(R)