Download F - HB Ar Comprimido
Transcript
4.2 Installation Guidelines Only competent personnel trained, qualified and approved by domnick hunter should perform commissioning and service procedures. Ensure the dryer is correctly sized for the inlet pressure, taking into consideration pressure drops caused by valves, pipes, filters etc. Allowance should be made for purge air loss. The dryer should be typically sized at 1 bar (14 psi ) 0.1MPa below nominal compressor output pressure. Ensure PNEUDRI is correctly sized for inlet temperature to meet the dewpoint specified. -20°C (-4°F), -40°C (-40°F) or -70°C (-100°F). It is recommended that a receiver be fitted before the dryer to ensure optimum performance. The dryer should only be lifted by the lower manifold using a fork lift truck or similar. Do not drop the dryer or attempt to move it while support legs are in contact with the ground. Do not remove any support leg or compromise support leg integrity in any way (e.g. grinding, drilling or welding). Locate the dryer indoors in a well ventilated area. Ensure that there is sufficient space around the equipment for maintenance and access for correct lifting equipment. Ensure minimum distance between dryer bank centres is 750mm (29.5”). Ensure there is sufficient headroom above the dryer to enable the top manifold to be removed, this should be no less than 1m. Noise considerations should be taken into account when choosing a site for the dryer. Exhaust silencers are supplied, ensure that these are fitted after installation. Ensure the dryer is securely mounted on a flat and level floor or base that is free from vibration. It should be secured to the base using correct bolts through the slots in the support legs. On multibank installations dryers should be located in an end fed manifold arrangement using long radius T’s and elbows, as shown below. Pipework should be sized for correct flows and in accordance with local legislation. Ensure that a suitably rated system pressure relief valve protects the dryer and pipework. 8