Download FM1000ASFE3

ENGLISH
Note: A plumbing permit and services of a licensed
plumber may be required in some areas.
to start the automatic icemaking process. To
ensure continuous operation, make sure that:
* Water supply pressure should be minimum 0.5
bar and maximum 8 bar. If the pressure exceeds
8 bar, use a proper pressure reducing valve. Do
NOT throttle back the supply tap.
* The water supply tap is on, and
* The icemaker is connected to the power supply.
Note: The flake size is adjustable to standard and
large sizes. The adjustment is made by
removing one of the two identical cutters
combined together. The unit is shipped
from the factory in the standard size. If
adjustment is desired, please contact an
authorized Hoshizaki service company.
* The icemaker drain is gravity flow, so ensure
drain pipe has an adequate pitch or fall.
* Water should drain into an open trap.
II. OPERATING INSTRUCTIONS
2. PREPARING THE ICEMAKER FOR LONG
STORAGE
WARNING
1.This icemaker is designed to produce
edible ice. To keep the icemaker hygienic:
* Wa s h y o u r h a n d s b e f o r e r e m o v i n g
ice. Use the Plastic Scoop provided
(accessory).
* The Storage Bin is for ice use only. Do
not store anything else in the Bin.
* Clean the Storage Bin before use (see “III.
1. CLEANING”).
* Keep the Scoop clean. Clean it by using
a neutral cleaner and rinse thoroughly.
* Close the Door after removing ice to
prevent entrance of dirt, dust or insects
into the Storage Bin.
1)Push the Stop Button on the Operation Panel. The Display will blink in the “STOP” mode for 15
minutes during the drain control operation and
will start to illumintate constantly at the end of
drain control.
2)Close the water supply tap.
3)Remove the Inlet Hose from the water tap, and
drain the Hose.
4)Disconnect the power supply.
5)Remove all ice from the Storage Bin, and clean
the Bin.
2.T h e u s e o f a n y e l e c t r i c a l e q u i p m e n t
involves the observance of some
fundamental rules. In particular:
* Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in
doubt, disconnect the icemaker.
* Do not pull the power cord in order to
disconnect the icemaker from the feed
network.
* T h i s a p p l i a n c e i s n o t s u i t a b l e f o r
unsupervised use by young children or
aged or infirm persons.
III. MAINTENANCE
1. CLEANING
WARNING
1.B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
maintenance operations, disconnect
the icemaker from the electrical supply
network.
2.Ask a trained service person to check and
clean the Condenser at least once a year.
3.All parts are factory-adjusted. Improper
adjustments may result in failure.
3.This appliance must not be cleaned by use
of a water jet.
4.If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the Compressor.
[1] Machine and Bin Exterior
1. OPERATION
Wipe the exterior at least once per week with a
clean, soft cloth. Use a damp cloth containing a
neutral cleaner to wipe off grease or dirt.
The installer will normally commission the icemaker