Download MD20B

6-2. Reference Point Setting
1
2
Check that the R.ADJ switch is set to OFF.
When setting direction where reference point is located
4
3
R.ADJ
DIR
1 2 3 4
Setting procedure
In the interpolator, the positional relationship between the reference
point signals and scale signals must be set in order to output a
reference point in synchronization with the scale signals. After
mounting the scale and reference point sensor, be sure to always
make the settings below.
Check that it is OFF
Move the scale in the opposite direction from where the
reference point will be located, and then pass through the
reference point. After passing through the reference point,
check that the REF lamp is turned off.
REF
REF lamp is off
Opposite direction from reference point location
MD20B
(E) 19