Download superhummel

SUPERHUMMEL
ATTENTION!
➔
14
Never reach into the area of the belt while it is running. During the test run,
ensure that no objects randomly positioned in the vicinity can be picked up by
the sanding belt. This could result in serious injury or damage to the machine!
Close the side cover.
Your machine is now ready.
Before working with the machine for the first time, operating staff must be adequately
instructed!
3.2
Starting the machine
ATTENTION!
➔
Never switch on the motor before tensioning the sanding belt!
➔
Never switch on the motor unless the sanding drum is raised off the floor!
➔
Let the machine not run unattended and always pull the power plug out of the
socket if work is concluded!
The machine can be started after preparation. To start the motor, go on switch position -STARTfor approx. 2 seconds till the motor has reached the full revolutions per minute.
Staying too long on switch position -START- shortens the life span of the starting capacitor!
Release switch knob when the motor has reached the full revolutions per minute. The switch now
takes automatically the position -WORKING-.
If the motor should ever be difficult to start in extremely cold conditions, switch off the machine
and the V-belt tension should be relaxed by loosening the eye bolt or cross grip respectively.
Lower belt tension will allow the motor to start up more easily. Once the motor is up to
temperature, switch off the machine and remember to retension the belts using the eye bolt or
cross grip respectively.
3.3
Switching off the machine
To switch the machine off, raise the sanding drum off the floor by actuating the lowering lever and
turn the switch button to the -0- position. Wait until the sanding drum comes to a standstill before
replacing the machine down onto the sanding drum.
➔
50
Let the machine not run unattended and always pull the power plug out of the
socket if work is concluded!
Ersatzteile - Bedienungsanleitung / Spare parts - Operating instructions
01.04.2006