Download IP-1000 USER MANUAL
Transcript
English - German - French - 中 文 liquids may cause clogging or damage the fog machine. Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage to the pump as well as over-heating of the heater. If your fog machine fails to work properly, discontinue use immediately. Pack the unit securely (preferably in the original packing material), and return it to your ANTARI dealer for service. Pay attention to all warning labels and instructions printed on the exterior of your ANTARI fog machine Unpacking & Inspection Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. The shipping carton should contain the following items: 1. 2. 3. 4. One unit of IP-1000 Fog Machine Fluid tube Fluid filter User manual If any equipment is missing contact your ANTARI dealer immediately. Before beginning your initial setup on your ANTARI fog machine, make sure that there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance. Setup Remove all packing materials from the shipping box. Check that all foam and plastic padding is removed, especially in the nozzle area. Place the fog machine on a flat surface. Place the fluid tube into a properly filled fluid tank. Fill with only Antari-authorized Fog liquid. The Antari IP-1000 only works with uncontaminated Antari FLR or FLG Fog Liquid. Other fluids may cause spitting and other clogging problems and could result in the production of an unhealthful fog. The use of other fluids will void the warranty of the Antari IP-1000. When filled, please place the cap back on the liquid tank. Operation Connect the fog machine to a grounded power outlet. As soon as the unit is plugged in, the heater starts to heat up. When the green light of the controller is on, the heating process is completed successfully. Press and depress the switch on the remote control to adjust the fog output. Note that there are no timer or any other controllers available for this model (no optional accessories). DMX Operation There is no DMX function available for the Antari IP-1000. Important: Always monitor the tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit. Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Always replace the caps on the fog liquid container immediately after filling to avoid contamination. 02
This document in other languages
- français: Elation IP-1000 IP63 Rated Fogger
- Deutsch: Elation IP-1000 IP63 Rated Fogger