Download english - Reloop

6.3 Troubleshooting
SYMPTOMS
POSSIBLE CAUSES
CORRECTIVE MEASURES
The device does not receive any
power when turning it on via the On/
Off Button -B44-.
USB cable is not connected correctly.
Check whether the USB cable is connected to a USB
port of your computer and the USB port of Terminal
Mix 2 -B45-.
The controller‘s LEDs are only weakly lit and the device does not react.
The power supply is not sufficient.
Please install the ASIO driver again. To do so please
also read the paragraph “ASIO Driver Installation” in
the chapter “Computer configuration”.
Not all outputs of the integrated
audio interface can be selected in
the DJ software.
The ASIO driver is not installed correctly.
Bitte installieren Sie den ASIO-Treiber erneut. Lesen
Sie dazu bitte den Abschnitt „ASIO Treiber-Installation“ des Kapitels „Computer-Konfiguration“.
The audio interface‘s sound is
distorted.
- The ASIO driver is not being used.
- The performance settings do not correspond to the computer‘s capacity.
- Please make sure that the ASIO driver is installed
and is also being used. To do so please read the
paragraph “ASIO Driver Installation” in the chapter
“Computer Configuration”.
- It is also possible that in the ASIO driver‘s settings
the available computer capacity has to be reconfigured. To do so open the Reloop ASIO settings
and increase the “ASIO Buffer”.
There is a problem that is not listed
here.
Various causes.
Visit the website www.reloopdj.com/forum to get
support for your Reloop products.
ENGLISH
If a problem should arise while using Reloop Terminal Mix 2 the following chart is the first drop-in center:
27