Download Swiss SA

Manual instruction
operator from the safety instructions and safe
working practices given in this manual.
EN
• The main voltage must correspond to the one
marked on the technical data plate. Do not use
other sources of power.
• The use of a safety circuit-breaker is
recommended for the power supply line for an
intervention range of 10 to 30 rated mA. Consult a
reliable electrician.
• Before inserting the plug in the mains socket,
make sure that the socket ratings are correct and
correspond to those indicated on the rating label on
the appliance.
Specific safety rules
• Make sure that the device is switched off before
inserting the mains plug into the socket.
• Always pull the mains plug out before carry out
cleaning or maintenance work. This is to prevent the
device starting up by accident.
• The ventilation openings (2) of the motor unit (3)
must always be kept clear. Otherwise there is a risk
of the device overheating.
• When carrying out work on the device as well as
transporting or storing it, move the On/ Off switch
(4) to the “0” position (off ) in order to prevent it
switching itself on by accident.
CAUTION: Fire hazard due to flying
sparks! Make sure there’s no person and
combustibile material in the vicinity.
CAUTION: touching electrified parts may cause
death by electric shock or burn.
• Never move the appliance by pulling at the
cables.
• Always guide the connection line safely.
• Do not use power tools near flammable liquids
or gases.
• Always disconnect the appliance from the mains
supply before transporting it to other places.
CAUTION: The appliance should always be
switched off at the mains before disconnecting any
plug and socket connector or extension cables.
• Never pass the appliance over the extension
cable while the tool is working. Make sure you
always know where the cable is.
• Do not wire an extension cable directly into your
device yourself. Instead, take the device to your
nearest Performance Power service agent.
ATTENTION! DANGER OF ELECTRIC SHOCK!
Consider work area environment. Do not expose
power tools to rain. Do not use power tools in
damp or wet locations. Keep work area well lit and
dry. Try to prevent the device from getting wet or
being exposed to humidity. Do not leave it outside
overnight.
• The power supply cable should be checked
regularly and before using it , make sure the cable
is not damaged or worn out. If the cable is not in
good condition, do not use the appliance; take it to
an authorized service center instead.
• When tool is used outdoors, only use an
extension cable that is suitable for outdoor work
and so marked. Keep it away from the working area,
from damp, wet or oily surfaces and away from heat
and fuels.
ATTENTION: Use the On/Off switch (4) to
switch the grinder off in the event of a
power failure or when pulling out the
mains plug. This prevents the grinder restarting
by accident, which could cause injury to you.
• Never operate the grinder if the power cable or
mains plug is damaged.
• Grinding stones must be carefully stored
and handled according to the manufacturer’s
instructions.
• Make sure that the grinding tools are appropriate
in line with the instructions of the manufacturer.
• Check the grinding stone before using it; do
not use any broken, cracked or otherwise damaged
goods.
• Make sure that a grinding tool is correctly fitted
and fastened before using it. Place the grinder in a
safe place and allow it to run idly for 30 seconds.
Stop it immediately if considerable oscillations
occur or if defects are observed. If this occurs, check
the machine to find out the cause.
Unpacking
When unpacking, check to make sure that all
components are included. Refer to the drawings
on this manual. If any parts are missing or broken,
please call IVT assistance center.
Initial operation
Always use the correct supply voltage: the power
supply voltage must match the information quoted
on the tool identification plate.
10