Download martin yale 2601

MARTIN YALE
GB
2601
4.6 Manual Fold Setup
4.7 Manual Feeding
Setting a standard fold with non-standard size paper
The manual feed mode allows you to hand feed sets of 2 or more sheets,
loose, glued or stapled. The limit is 5 sheets of 80 g/m² bond, folded into
a single, letter (C) or Z fold.
Press the Fold Type key to select the desired type of standard fold.
DO NOT attempt to fold sets into any other type
of fold. This could result in serious damage to the
machine.
Press the Paper key until the “Other” indicator lights.
The display will show:
T1
CHG:
PAPER = 297.0
DONE: Enter
In manual feed mode the fold rollers will be turning but the feeder is
disabled. Automatic feeding is not possible, paper is fed by hand, one
set at a time.
Use the
or
keys to change the dimension shown to the length
of your paper in millimeters. Press Enter and the fold will be setup
automatically.
Setting the feeder for manual feed
Press the Manual Feed key. The display will say:
The display will first show ...
MANUAL FEED MODE?
YES: Enter
NO:
TEMP JOB: 1
SETTING
Press Enter. You will hear a small motor opening the feeder gap, which
will enable you to feed more than one sheet at a time.
... then return to the normal running mode display.
Run a trial piece to check the fold. If necessary make corrections as
described on page 12.
After the motor stops, the display will shows:
MANUAL FEED
Setting a non-standard fold with any size paper
Press the Paper key to select any of the 3 standard paper sizes, or select
“Other” and set the paper size as described above.
READY
123456
Press Start and start feeding your collated sets one by one. In order to
get cleanly folded sets, make sure to insert the sets straight down the
paper guides on the feed table.
Press the Fold Type key to set fold plate 1. Measure the length of the
first fold on your sample and transfer the measurement using the
or
keys.
Returning to automatic feed
To get out of the manual feed mode, press the Manual Feed key again.
The display will ask:
Press Fold 2 and transfer the measurement of the second fold. If your
special fold is a single fold, you don’t need to set fold plate 2.
MANUAL FEED EXIT?
YES: Enter
Press Enter, the machine will set itself automatically.
Run a trial piece to check the fold. If necessary make corrections as
described on page 10.
NO:
Press the Enter key. The display will say:
INSERT ONE SHEET
DONE: Enter
Note: the machine's electronic control system will not allow you to
deviate too far from the standard settings. This will prevent jams caused
by “impossible” folds.
Insert a sheet of paper to be fed automatically and press Enter. The
machine will set the sheet gap to the thickness of the sample sheet and
the display will return to normal running mode.
Remove the sample sheet or press Trial Piece to feed the sheet through
the machine.
30