Download ADanger

ENGLISH
8.4
section
Width
approx.
Height
approx.
15°
246
60
22.5°
235
60
30°
220
60
45°
177
60
3 Note:
The compound
mitre cut is a
combination of mitre and bevel cut. This
means the workpiece is cut at an angle
other than 90° against the rear guide
edge and against its surface.
A Danger!
When
cutting
compound
mitres the saw blade is much more
exposed than normally - increased
risk of injury. Always keep sufficient
distance to the saw blade.
Starting position:
Sawhead fully raised.
−
Cutting depth limiter set to maximum depth of cut.
−
Motorhead in vertical (90°) position,
bevel tilt locking lever tightened.
−
Track arm not extended.
−
Locking screw of the track arm loosened.
Cutting the workpiece:
1.
Loosen the locking screw (46) of the
rotating table (44) and disengage
the table lock lever (45).
Maximum workpiece
(dimensions in mm):
Motor head
inclination
−
Compound mitre cuts
cross
section
Width
approx.
Height
approx.
22.5°
255
53
45°
255
30
Starting position:
−
Sawhead fully raised.
−
Cutting depth limiter set to maximum depth of cut.
−
Rotating table in 0° position, the lokking screw of the rotating table is
tightened.
−
Track arm not extended.
−
Locking screw of the track arm loosened.
Cutting the workpiece:
1.
Loosen the ratchet lock lever (47)
for sawhead tilt at the rear of the
saw.
Maximum workpiece
(dimensions in mm):
cross
section
Width with sawhead tilted approx.
Rotating table
position
cross
22.5°
45°
15°
246
246
22.5°
235
235
30°
220
220
45°
177
177
Height with sawhead tilted approx.
Rotating table
position
Rotating table
Maximum workpiece
(dimensions in mm):
22.5°
45°
15°
53
30
22.5°
53
30
30°
53
30
45°
53
30
Starting position:
44
45
46
−
Sawhead fully raised.
−
Cutting depth limiter set to maximum depth of cut.
−
Rotating table locked in desired
position.
positive stops at the 0°, 15°, 22.5°, 30°
and 45° position.
−
Sawhead tilted to desired angle
against the workpiece's surface and
locked.
3.
Tighten the rotating table's locking
screw.
−
Locking screw of the track arm loosened.
4.
Cut workpiece as detailed under
"Standard cross cuts".
−
Track arm not extended.
2.
Set to desired angle.
3 Note:
The rotating table engages into
8.3
47
Cutting the workpiece:
•
Bevel cuts
3 Note:
A bevel cut cuts the workpiece at
an angle other than 90° against its surface.
2.
Tilt the track arm holder slowly into
the desired position.
3.
Tighten the sawhead tilt locking
lever.
4.
Cut workpiece as detailed under
"Standard cross cuts".
Cut workpiece as detailed under
"Standard cross cuts".
21