Download CHARGER U4
Transcript
switch will start the charge process with 0.8A current. If no error occurs, (CHARGE) will remain lit during the whole charging session until the battery is charged to 14.4V. When the battery is fully charged, the LED (FULL) will be lit, and a trickle charge takes place to keep the battery properly charged. [3] MODE 2 (14.4V/3.8A; > 14Ah) This mode is meant for charging batteries with larger capacity of more than 14Ah. To charge the battery, connect the output connectors of the charger to the battery with the right polarity. After selecting the operation mode once the charging process can be started by pressing the mode button. The corresponding LED (>14Ah) will light up and after a short delay, if no further operation is conducted, the electronic switch will start the charge process with 3.8A current. If no error occurs, (CHARGE) will remain lit during the whole charging session until the battery is charged to 14.4V. When the battery is fully charged, the LED (FULL) will be lit, and a trickle charge takes place to keep the battery properly charged. [4] MODE 3 (14.7V/3.8A; COLD) This mode is established for charging those batteries with larger capacity of more than 14Ah in cold ambient condition or charging some AGM batteries with capacity of more than 14Ah. To charge the battery, connect the output connectors of the charger to the battery with the right polarity. After selecting the operation mode once the charging process can be started by pressing the mode button. The corresponding LED (COLD) will light up and after a short delay, if no further operation is conducted, the electronic switch will start the charge process with 3.8A current. If no error occurs, (CHARGE) will remain lit during the whole charging session until the battery is charged to 14.7V. When the battery is fully charged, the LED (FULL) will be lit, and a trickle charge takes place to keep the battery properly charged. [5] RESCUE DEEP DISCHARGED BATTERY 14