Download Eignungsprüfbericht für Gaskomponenten

TÜV Rheinland Energie und Umwelt GmbH
Air Pollution Control
Report on performance testing of the Fidas® 200 S measuring system manufactured by PALAS GmbH for the components suspended particulate matter
PM10 and PM2.5, Report no.: 936/21218896/A
Page 23 of 476
Performance criterion
Specification
Test result
Fulfilled
Page
5.3.4 Linearity (lack of
fit)
The analytical function describing the relationship between
the output signal and the value
of the air quality characteristic
shall be linear.
Particulate measuring systems for
PM10 shall be tested according to
performance criterion 5.4.2 “Equivalency of the sampling system”.
-
92
5.3.5 Sensitivity coeffi- The sensitivity coefficient of the Not applicable.
cient of sample
sample gas temperature at refgas pressure
erence point shall not exceed
the specifications of Table 2 of
VDI Standard 4202, Sheet 1
(September 2010).
-
93
5.3.6 Sensitivity coeffi- The sensitivity coefficient of the Not applicable.
surrounding temperature at zecient of sample
gas temperature ro and reference point shall not
exceed the specifications of
Table 2 of VDI Standard 4202,
Sheet 1 (September 2010).
-
94
yes
95
5.3.7 Sensitivity coefficient of surrounding temperature
The sensitivity coefficient of the
surrounding temperature at zero and reference point shall not
exceed the specifications of
Table 2 of VDI Standard 4202,
Sheet 1 (September 2010).
Particulate measuring systems for
PM2.5 shall be tested according to
performance criterion 5.4.10 “Calculation of expanded uncertainty between
systems under test”.
The ambient temperature range tested at the AMS installation site was 20 °C to +50 °C. Looking at the values that were output by the AMS, the
maximum dependence of ambient
temperature in the range of -20 °C to
+50 °C at zero was -1.1 x 10-5 µg/m³
For PM:
for PM2.5 and -1.1 x 10-5 µg/m³ for
Zero point value for ∆Tu of PM10.
15 K between +5 °C and +20 At reference point, no deviations >
°C or 20 K between +20 °C 5.0 % for PM2.5 and > 4.6 % for
and +40 °C shall not exceed PM10 in relation to the default temB0.
perature of 20 °C were observed.
The measurement value in the
range of B1 shall not exceed ±
5 % for ∆Tu of 15 K between
+5 °C and +20 °C or for 20 K
between +20 °C and +40 °C
1_3185580_2013_936_21218896A_EN.doc