Download LAB 3100 - GCE Group
Transcript
Below is non-conclusive list of the gas labelling. If you are in doubt, please, check EN13792. 3 2 1 GASES 2 3 yellow white green Butan - C4H10 yellow blue blue Argon / Methan - ArCH red yellow gray Hydrogen - H2 red red red Argon - Ar blue gray gray Carbogen (CO2 + O2) - CB blue black blue Press air - LD blue blue yellow Helium - He blue gray white Carbon dioxide - CO2 blue blue black Oxygen-O2 blue blue blue Nitrogen - N2 blue green green Synth. air 80/20 - LS blue blue green Carbon monoxide - CO black blue black table 1 2.15.2. Marking on Rating Plate The rating plates have the following markings: Attention! pressurized parts, Service only by authorized Pin: 40 bar personnel. OXYGEN Pout: 0,5 - 10 bar Typ: EMD 3100-01 Mat: Ms / Ni / PVDF 14.07. Manufacturer EN 1 Acetylen-C2H2 Explanation: Manufacturer, date of manufacture 14.07. = Juli 2014). Type designation, permitted pressure (pin). device-specific outlet pressure range (pout). Materials of pressure reducing chamber (Ms = brass I ES =special steel, surface coating (Ni = nickel for brass housing and seat seal (PVD, FKM/FFKM [fibre-reinforced plastic). PCTFE). Safety information and the permitted type of gas. The valves also have a marking showing the direction of flow of the gas (inlet to Outlet marked with an arrow) The serial number, which is specific to the device, is shown on a separate plate in barcode 128 and in clear text. 2.15.3. MARKING OF INLET AND OUTLET Inlet and outlet threads of PoU regulators and valves bodies are indicated with a lasered marking: Marking Inlet: 22/36 Outlet: