Download LAB 3100 - GCE Group

Transcript
Below is non-conclusive list of the gas labelling. If you are in doubt, please, check EN13792.
3
2
1
GASES
2
3
yellow
white
green
Butan - C4H10
yellow
blue
blue
Argon / Methan - ArCH
red
yellow
gray
Hydrogen - H2
red
red
red
Argon - Ar
blue
gray
gray
Carbogen (CO2 + O2) - CB
blue
black
blue
Press air - LD
blue
blue
yellow
Helium - He
blue
gray
white
Carbon dioxide - CO2
blue
blue
black
Oxygen-O2
blue
blue
blue
Nitrogen - N2
blue
green
green
Synth. air 80/20 - LS
blue
blue
green
Carbon monoxide - CO
black
blue
black
table 1
2.15.2. Marking on Rating Plate
The rating plates have the following markings:
Attention!
pressurized parts, Service
only by authorized
Pin: 40 bar
personnel.
OXYGEN
Pout: 0,5 - 10 bar
Typ: EMD 3100-01
Mat: Ms / Ni / PVDF
14.07.
Manufacturer
EN
1
Acetylen-C2H2
Explanation:
Manufacturer, date of manufacture 14.07. = Juli 2014). Type designation, permitted pressure
(pin). device-specific outlet pressure range (pout). Materials of pressure reducing chamber
(Ms = brass I ES =special steel, surface coating (Ni = nickel for brass housing and seat seal
(PVD, FKM/FFKM [fibre-reinforced plastic). PCTFE). Safety information and the permitted
type of gas. The valves also have a marking showing the direction of flow of the gas (inlet to
Outlet marked with an arrow) The serial number, which is specific to the device, is shown on a
separate plate in barcode 128 and in clear text.
2.15.3. MARKING OF INLET AND OUTLET
Inlet and outlet threads of PoU regulators and valves bodies are indicated with a lasered
marking:
Marking
Inlet:
22/36
Outlet: