Download Benutzerhandbuch

9. Operation
1.) Charge the batteries fully by connecting the UPS to the
mains supply for 1-2 hours. Although you can use the UPS
immediately without charging, the autonomy time in the
event of a mains failure may be shorter than the rated
value indicated.
2.) Make sure that the UPS output voltage is the same as that
of your computer (usually 230V). You can set the UPS
output voltage with the software.
3.) Connect your computer to the UPS output socket using
the 10A appliance extension cable for non-heating appliances supplied with the product.
CAUTION:
Do not connect any appliances to UPS output
sockets which will overload the UPS (e.g. laser
printers). Do not connect any household appliances to the UPS.
9.1 Operating modes
XANTO RT features three operating modes:
1.) Normal mode:
The load is supplied with power by the inverter as long as the
power supply voltage remains within the defined tolerance.
Power is supplied to the inverter by the rectifier.
In this operating state, the “LINE” and “INVERTER” LEDs light
up.
Seite 69 von 128
Manual-XantoRT_ger-engl-ital_final_20090929.doc
30.09.2009, Dipl.-Ing. Sven O. Spitzley