1
Download AirSmart-Controller - Schneider
Transcript
4. Adjustment Menus Adjustment menus Operation Adjustment Maintenance Adjust Unit Setup Adjust Configuration Adjust LANGUAGE OIL FLTR IN UNIT PASSWORD COMPRESSOR MODEL TARGET PRESSURE OIL CHNG IN OIL FILTER CHNG INT TOTAL RUN HOURMETER UNLOAD PRESSURE OIL SEPR IN OIL CHANGE INTERVAL LOADED HOURMETER LOAD PRESSURE AIR FLTR IN SEPARATOR CHNG INT REMOVE INTRSTG PRES SECONDARY PRESSURES NXT CBOX FLTR IN AIR FILTER CHNG INT REMOVE RES PRES PRESSURE UNIT MTR LUBE IN CTRL BOX FILTER INT REMOVE SEP PRES TEMPERATURE UNIT TOTAL COST MOTOR LUBE INTERVAL REMOVE PLANT PRES HIGH PLANT PRES LIM REMOVE OIL PRES START TIMER OVER TEMP LIMIT REMOVE SYSTEM PRES STOP TIMER TEMP ALARM LIMIT DISTRIBUTOR INFO 1 BLOWDWN TIMER PLANT TEMP LIMIT DISTRIBUTOR INFO 2 BLOWDOWN COUNTER PLANT ALARM LIMIT ENERGY COST OPERATING MODE AUTO TIME DRYER TEMP LIMIT SYSTEM VOLTAGE REMOTE HALT DRYER ALARM LIMIT ELEVATION AUTO RESTART MIN TARGET TEMP INLET TEMP OFFSET RESTART DELAY SELECT FAN TYPE INTRSTG TEMP OFFSET MOTOR JOG? DISCHARGE TEMP OFFSET DRAIN CLOSE INTERVAL SEP TEMP OFFSET IDLE TIMER DRAIN OPEN INTERVAL PLANT TEMP OFFSET LIMIT CAPACITY DRYER TEMP OFFSET MIN TARGET PRESSURE OIL TEMP OFFSET OIL TYPE PP ADV TIMEOUt Note! Items and menus marked with grey filled boxes may not appear on the controller depending on the composition and type of the compressor. All the passwords are entered under the Unit Setup Adjust menu. The Configuration Adjust menu is shown only if the passwords are entered. 19
