Download USER'S MANUAL

Transcript
6-3) Generating the basic pattern shapes
① Select DATAINFO by pressing the DOWN key in a status
that the ready lamp for sewing is turned off. It will be
transformed to the initial display of parameter information
change when pressing the ENTER key
↓
↓
② Select the‘2’Pattern by pressing the DOWN key 1 time on
the initial display of parameter.
OR
↓
③ When you press the ENTER key, the screen will be
transformed to the display for selecting a button shape.
Select a desired pattern shape using the UP, DOWN key, and
press the ENTER key.
(Example : Round shaped pattern)
↓
OR
↓
④ And then the screen will be transformed to the display to
generate patterns. You shall set up the up Bartack, the down
Bartack and the zigzag parts each for generating patterns.
1 : Up Bar (the up Bartack part)
2 : Zigzag (the zigzag part)
3 : Dn Bar (the down Bartack part)
※ Set up the up Bartack, the down Bartack and the zigzag parts each after manipulating the ①,②,③ and ④ commonly.
◀Note▶
When creating the basic pattern for the first time, pressing the READY key in step④ will lead to the creation of pattern based on default
value, even if the parameter value for defining the pattern has not been changed.
◀Note▶
When changing the shape of the previously saved pattern, the pattern can be created with the previously saved value by pressing the
READY key in step④, even without changing the pattern-setting parameter value.
◀Note▶
When setting the top and bottom Bartacks, the value of pitch cannot be set at values higher than those of the length.
23