Download Operating Instructions

Configuring the USER SETUP Menus
Number Of Copies
Median Complex Page
[Numeric. Range = 0-5]
Sets the number of complete report copies to print in addition to the automatic
printout.
ON
OFF
Enables Median Complex printout as part of every Auto ECG report.
Print Mode
AUTO
MANUAL
OFF
Determines how ECG reports are printed. If AUTO is selected, then reports
automatically print out prior to saving. If OFF is selected, no report is printed prior to
saving. If MANUAL is selected, then prior to saving the unit will display a message
asking whether to print the record.
Save Mode
AUTO
AUTO SAVE AND SEND
MANUAL
Determines how Auto ECG reports are saved. If AUTO is selected, reports will be
automatically saved after printing. If MANUAL save is selected, the PREVIEW
screen is displayed at the end of every Auto ECG sequence. You may save the report
at this time. If AUTO SAVE AND SEND is selected, then the report is automatically
saved; the report is also sent automatically to an ECG Management System, such
as the PYRAMIS System or the FAA System.
Wait for good data
ON
OFF
When ON, Auto ECG reports are delayed until ten seconds of low noise waveform
have been collected (all electrodes must be connected). An immediate report can be
forced by pressing ECG a second time. In this case, if data is noisy, the report will
state “Warning: Data quality may affect computer interpretation.”
When OFF, the Auto ECG report starts once at least 10 seconds of ECG waveform
has been collected, regardless of the quality of the collected waveform data. No
warning message is printed in this case.
NOTE: If any electrodes are disconnected the report will show a flat baseline for
those leads. (“Overload” conditions will also produce a flat baseline.) Leads with
disconnected electrodes will not be used in the ECG analysis.
Annotate R-R Intervals
ON
OFF
When ON, R-R intervals are printed at the bottom of the 12-lead report. For
additional information, see “R-R Intervals” on pg. 11-4.
CUSTOM LEAD 1 & CUSTOM LEAD 2
These two menus each format a group of leads. These groups can later be
selected by pressing the “5” or “6” machine control keys (see “The Keyboard”
on pg. 3-1).
Custom Lead Group 1 is also used for the rhythm page of an Auto ECG report.
Only Standard or Cabrera configurations are acceptable for this purpose. Do
not select Frank or Nehb if you want a rhythm page as part of an Auto ECG.
Eclipse Operating Instructions
4-9