Download SERIAL EPROM PROGRAMMER USER'S MANUAL For

3.1
Help (H)
Syntax:
1. H <ret> or ? <ret>
2. H <command> <ret> or ? <command> <ret>
Example:
1. h
2. ? sb
3. h prog
: shows the general HELP window
: gets help on the Show Buffer command
: gets help on the Program command
Description:
The Help command provides on-line help services to the user. This help describes the syntax
and operation of the Serial Eprom Programmer commands.
If form (1) is used, a panel listing all the commands available is displayed. This panel appears as
follows:
HELP PANEL
---------H or ? or HELP -- Invoke Serial Eprom Programmer Help
GENERAL -- General Help on using the Serial Eprom Programmer
VER
-- Display Firmware Version
DIAG
-- Enter Diagnostics Submenu to Test Hardware
DB
-- Display 256-byte Buffer Block
DE
-- Display 256-byte Eprom Block
FB
-- Fill Buffer with Byte
E
-- Edit Buffer
DL
-- Download Data to Buffer from Computer
T
-- View Current Eprom Type or Select New Eprom Type
B
-- Blanktest Entire Eprom or Subrange of Eprom
C
-- Copy from Eprom to Buffer
PROG
-- Program Eprom from Ram Buffer
SB
-- Search Buffer for Byte Pattern
SE
-- Search Eprom for Byte Pattern
U
-- Upload Intellec (Intel Hex) File from Buffer to Computer
V
-- Verify Eprom against Buffer
M
-- Move Buffer Block
CHKB
-- Perform 16-bit Buffer Checksum Calculation
CHKE
-- Perform 16-bit Eprom Checksum Calculation
15