Download CodeVisionAVR User Manual

CodeVisionAVR
5.13.1 Setting the LM75 devices
If you use the LM75 temperature sensor, you must select the LM75 tab and check the LM75 Enabled
check box.
The LM75 Address list box allows you to specify the 3 lower bits of the I2C addresses of the LM75
devices connected to the bus. Maximum 8 LM75 devices can be used.
The Output Active High check box specifies the active state of the LM75 O.S. output.
The Hyst., respectively O.S. , spinedit boxes specify the hysterezis, respectively O.S. temperatures.
The LM75 devices are accessed through the National Semiconductor LM75 Temperature Sensor
Functions.
© 1998-2008 HP InfoTech S.R.L.
Page 213