Download User Manual

5 FRONT RIGGINGS
5.7
Heel Loop Replacement
1.
Remove the two bolts and locknuts that secure the lower footrest assembly to the upper footrest support.
2.
Remove the lower footrest assembly.
3.
Remove the mounting screw, spacer and locknut that secure the existing heel loop to the footrest.
4.
Slide existing heel loop over the slide tube of the lower footrest assembly.
5.
Install new heel loop.
6.
Reverse STEPS 1-4 to reassemble.

When securing the heel loop to the footrest assembly, tighten the mounting screw and locknut until the spacer is secure.
Bolts
Locknuts
Mounting
Screw
Heel Loop
Spacer
Slide Tube
Lower Footrest
Assembly
Locknut
FIGURE 7 Heel Loop Replacement
Invacare®9000 Topaz™Wheelchair
36
Part No 1100869