Download User's Manual
Transcript
6.2 Overview, Continued Configuration decision summary, continued Figure 25 Flowchart — ST 3000 Pressure Transmitter Configuration, continued. A Do you know how much damping time is needed? NO Determine appropriate damping time value for your process. We suggest that you set the damping to the largest value that is reasonable for your process. YES See procedure in Table 23 for selection details. Press [ DAMP ] key and use [ NEXT] or [ PREV] key to select stored damping time value through SFC prompt DAMP 1. Select desired damping time value in seconds through the SFC prompt DAMP. Do you know what engineering units to use for pressure readings? NO See Unit of Measurement in Table 24 for list of available pre-programmed engineering units in the SFC. YES Select desired pre-programmed engineering units through SFC prompt UNITS. See procedure in Table 24 for selection details. Call up a pressure value on the SFC display and repeatedly press [UNITS] key to select desired pre-programmed engineering units through the SFC prompt UNITS 1. B Continued on next page 68 ST 3000 Release 300 and SFC Model STS103 User’s Manual 6/05