Download User Manual - FELIXprinters

User manual FELIX 3.0 3d printer
4 Software Installation – Microsoft Windows
4.1 Microsoft Windows
NOTE: Mac users should go to chapter 4.2
This chapter describes the steps how to make the printer communicate with your PC.
-
4.1.1
Repetier-host
Driver installation
Firmware installation
Printer Software – Repetier-Host
Repetier-Host provides the following functions:
Control your printer, move axes and set temperatures, monitoring etc.
Process your CAD files (STL files) and make them printable.
To install Repetier-Host on your PC take the following steps:
1. Download the latest version of Repetier-Host from www.FELIXprinters.com/downloads
Navigate to the software folder and download setupRepetierHostFELIXprinters*.exe
2.
3.
4.
5.
Select your printer type, single or dual head
In the configuration window press the Refresh Ports button.
Page
7
6.
Run the setupRepetierHostFELIXprinters*.exe file and follow the installation instructions.
During installation it will ask to install a driver. This is recommended to do.
Make sure the power cable and USB cable of the printer are connected.
Start Repetier-Host.
Go to Config -> Printer settings.
[email protected]
www.FELIXprinters.com