Download Trapeze RingMaster User's Guide

4. Click OK. Devices are added to the ignore list and disappear from the list of rogues in the Alarm
screen.
Adding a Device to the Rogue List
The rogue list is a list of AP MAC addresses belonging to a switch. RingMaster attacks the AP MAC
addresses in the rogue list whenever they are present on the network.
1. From the list of rogues on the Alarm screen, select devices you want to place on the rogue list.
2. Click Add to Rogue List in the Tasks panel. The Select Devices dialog is displayed.
3. If the MXs on which you are configuring a rogue list are in a Mobility Domain, select the Mobility
Domain. Otherwise, select None.
4. Click next to Select to select all MXs listed, or select individual MXs.
5. Click OK. Devices are added to the rogue list. If countermeasures are enabled, MSS uses them to
attack devices on the list.
Converting a Rogue into a Third Party AP
If a device in the alarm list belongs to a third-party AP in your network, you can convert the rogue into a
third-party AP. When you convert a rogue into a third-party AP, the rogue disappears from the alarm list,
and allows you to place the AP in your network plan.
Converting a rogue into a third-party AP applies only to the network plan. RingMaster does not send
this information in any form to the MXs in the network. To prevent MSS from issuing
countermeasures against a third-party AP, you must also add the AP to the Ignore list. RingMaster
does send the Ignore list to the MXs in the network.
To convert a rogue into a third-party AP:
1. In the Alarm screen rogues list, select the device you want to convert to a third-party AP.
2. Click Create Third Party AP in the Tasks panel. The Third Party AP Properties dialog is displayed.
3. Enter the information for the AP and place the icon for the AP in the floor location, if applicable. (See
“Placing Third-Party Access Points” on page 105.) When you have finished, the AP appears under
Objects to Place in RF Planning.
4. To display the list, select the Configuration option in RingMaster Navigation Bar and click on Third
Party APs in the Organizer panel. Third-party APs are listed in the Content panel.
To remove a third-party AP:
1. Select the Configuration button on the RingMaster Navigation Bar and click on Third Party APs in
the Organizer panel. Third-party APs are listed in the Content panel.
2. Select the third-party AP to remove and click the Delete. The address is removed from the third-party
AP list. If a device is detected by rogue detection, it appears in the rogue list. Set the display filter of
the Rogue Detection screen to Current and click the Refresh option on the toolbar.
Adding Clients Belonging to a Rogue to the Black List
The Client Black List is a list of MAC addresses belonging to wireless clients not allowed on the network.
MSS prevents clients on the list from accessing the network through an MX.
1. In the Alarm screen, select the client to place on the Black List.
Displaying Rogue Information
Copyright © 2011, Juniper Networks, Inc.