Download Multi-ICE Version 2.1 User Guide

Using the Multi-ICE Server
3.2.2
Manual device configuration
You configure the Multi-ICE server manually by creating a server configuration file and
loading it into the Multi-ICE server. A complete description of the structure and
contents of the configuration file is provided in Device configuration file on page A-3.
To create the file:
1.
checking proclist.txt to determine if the device you are configuring is suported
by Multi-ICE. If:
•
•
The device type is not supported, you can name the device by creating a
device entry that tells Multi-ICE how long the scan chain select register for
the device is. See Naming an unsupported device on page 3-13.
The device type is supported, note the name of the device entry in the file
IRlength.arm. See The IRlength.arm configuration file on page 3-13 for
more information about this file.
2.
Open a text file editor, and create a new file, using the file extension .cfg.
3.
Enter entries in the text file for at least:
•
A TITLE section.
•
A TAP 0 section, containing the name used in IRlength.arm for the first
device.
Additional sections in the file might be required depending on the devices you are
configuring. Refer to Device configuration file on page A-3 for more information.
4.
Save the file.
5.
In the Multi-ICE server, click File → Load Configuration....
6.
Locate the configuration file you created, and click Open.
7.
The Multi-ICE server is configured to expect the devices you put in the
configuration.
Note
When you load a manual configuration, the Multi-ICE server does not check that
the devices you configure match the actual scan chain. It is your responsibility to
ensure this.
3-12
Copyright © 1998-2001 ARM Limited. All rights reserved.
ARM DUI 0048E