Download Operating Instructions for JHV

Transcript
0-5 Description for Manual Operating Key
Mold Open Key: Press it to perform the mold open stroke.
Condition: The current position of moved mold shouldn’t exceed the setting position value of
mold-open-end.
Mold Close Key: Press it to perform the mold close stroke.
Condition: The front and back safety door (19, 23), the robot end signal (18) and the ejector
ret. end (10) should be ON, but the mold-close-end (07) and the proximity should
be OFF.
Injection Key: Press it to perform the injection 1.
Condition: The cylinder temperature should be up to the set value and the setting button of
heater should be ON.
Suck-Back Key: Press it to perform the suck-back stroke.
Condition: The cylinder temperature should reach the set value.
Eject Ret. Key: Press it to perform the ejector backward stroke.
Condition: The proximity (10) of ejector ret. end should be OFF.
Eject Adv. Key: Press it to perform the ejector forward stroke; the ejector action will go on if
holding press.
Condition: Start from the mold-open-end position and the proximity of ejector adv. end should
be OFF.
Nozzle Adv. Key: Press it to perform the unit forward stroke; the slow nozzle adv. will be
acted if meeting the proximity of nozzle adv. end.
Condition: The mold close is finished before the unit forward, and the mold-close-end (7)
should be ON.
Nozzle Ret. Key: Press it to perform the unit backward stroke.
Core Out Key: Press it to perform the core A out stroke.
Condition: Core A used should be selected, and the action mode and position should be set.
~4~