Download Solution-16 Operators Manual

Solution-16 Operators Manual
19
Disarming From STAY Mode 1
Method One
• To Disarm Your System From STAY Mode 1
Enter your
followed by the
button.
Two beeps will be heard and the STAY indicator will extinguish. A flashing zone indicator
represents a previous alarm on that zone.
+
Method Two
• To Disarm Your System From STAY Mode 1
Hold the
button down until two beeps are heard.
The STAY indicator will extinguish. If your system does not disarm and you see a flashing zone
indicator, method one will need to be used. Method two does not operate after an alarm has
occurred.
Arming In STAY Mode 2
mode 2 is when the system has been armed with particular zones automatically isolated. Any
Master Code user can program these zones before the system can be armed in STAY mode 2.
Refer to “Master Code Functions” on page 28 for details on how to program zones for STAY
mode 2.
STAY
When there is a need to arm the perimeter of your building, this mode is extremely handy. It
automatically disables the interior detection zones allowing for movement within the protected
area while at the same time arming the perimeter zones.
• To Arm Your System In STAY Mode 2
Hold the 0 button down until two beeps are heard.
The STAY indicator will illuminate and any zones that have been programmed for STAY mode 2
will be automatically isolated and their respective indicators will begin to flash until exit time
expires. At the end of exit time the zone indicators will extinguish.
0
If a zone is not sealed at the end of exit time it will be automatically isolated. It will become an
active part of the system as soon as it is sealed (ie. If a window is opened before the end of exit
time, it will not be an active part of the system until it is closed. Opening the window after this
time will cause an alarm condition).
The feature of arming the system when a zone is not sealed is known as forced arming. If this
feature is not suitable, your installer can program your system so that it will not arm unless all
zones are sealed.
If the STAY indicator does not illuminate and a long beep is heard, forced arming is not permitted.
If this is the case, you must ensure that all zones are sealed or manually isolated before you will be
allowed to arm the system.
Electronics Design & Manufacturing Pty Limited
ISSUE140.DOC