Download User's Guide Manuel d'utilisation Manual de usauario

To change the Length or the Condense to fit option:
1) Press the Label Length key.
The Label Length window displays.
Label Length
Length (inches):
Condense to fit:
00.00.00
Off
Type values, press ↑↓, ENTER or ESC
2) To change the length, type a number within the valid range (as shown in the table
above).
3) To change the Condense to fit option, press the ↓ key to move the cursor to that option.
Then press the ← or → key to change the setting to On or Off.
Note the following points about the Condense to fit option:
•
If you try to change this setting when there is already text in the text buffer, an error
message displays instructing you to clear the text.
•
All lines on a label are condensed by the same amount.
•
This setting is ignored if you are working in a standard layout.
4) Press Enter when the settings you want to use are displayed.
The following message displays:
This change affects all labels in the
file. Continue?
Yes
5) To apply the change, choose Yes. If you don’t want to make the change, choose No.
If you applied the change, a change marker representing the option change appears in the text
entry area ( ).
Note: The setting you chose stays in effect for all labels until you either change
the setting or turn the system off. Repeat the steps above when you want to reset
an option.
Label Design
¡
3-17