Download Desktop 3 User's Guide

The control panel contains the following displays and switches, plus the
Desktop Image Marker switches (See Optional Accessories later in this
section).
1
2
Document
Counter
3
Reset 1
Out of Film
Indicator
Lamp
Failure
Feeder
Adjust
Indicators
Reset 2
Film
Odometer
Slow Film
Advance
Endorser
On/Off
Fast Film
Advance
Filming
On/Off
Image Marker Switches
(optional)
Figure 2 Control Panel
Reset 1: Press this button to reset the Document Counter to zero.
Reset 2: Press this button to reset the Film Odometer to zero.
Lamp Failure: Illuminates when a lamp needs to be replaced.
Feeder Adjust Indicators: Lamp Failure and Out of Film indicators flash
along with an audible beep when the feeder requires adjustment.
Film Odometer: An eight-digit odometer display is provided to index the
film images. Pressing the button below the display resets it to zero.
The display is also used to measure the leader and trailer when loading
and unloading film. Each unit on the display equals 4.8 inches (12.2 cm)
of film that have been advanced.
Endorser Power Switch (optional accessory): Turns the optional
Endorser on and off. When turned on, the green light above is
illuminated.
Filming Switch: Turns the filming unit on and off. The microfilmer
powers up in filming mode, and a green light indicates that you can begin
microfilming. A blinking yellow light indicates that the film unit has been
turned off. Documents can be counted or endorsed without exposing film
when the filming switch is turned off.
A-61036 July 2000
3