1
Download C40099 - Ratchet Banding Tool Operating Instructions
Transcript
Operating Instructions C40099 - Ratchet Banding Tool Instructions: Wrap object with appropriate band and buckle. Place band through tool as shown. Ensure that lever block under the cut-off handle is in locked position. Hold the cut-off handle steady while leveraging the tension handle to desired tension. With tool still in tension, bend band back over the buckle. Place lever block in open position and pull cut-off handle up until band is cut. Press the band down between the buckle ears and secure band with a hammer or mallet by pounding down buckle ears over remaining band tab to complete the clamp. Cut-off Handle Buckle Ears Tension Handle Lever Block Refer to website for warranty information: http://www.band-it-idex.com/warranty.html BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925 www.BAND-IT-IDEX.com Page 1 of 2 Document # P40050 Rev. D © Copyright BAND-IT-IDEX, Inc. 2008 All rights reserved C40099 - Ratchet Banding Tool Assembly and Repair Parts List C40073 C40071 C40057 C40066 2 places C40055 C40067 C40070 C40062 C40068 C40053 C40059 C40058 C40056 C40054 C40060 C40064 C40050 C40061 C40063 C40065 C40051 C40052 BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925 REPAIR PARTS LIST FOR C40099 PART # DESCRIPTION C40050 Lever block and spring C40051 Lock washer C40052 Pawl pin C40053 Lever pin C40054 Pin C40055 Screw C40056 Pawl stop A C40057 Pawl stop B C40058 Ratchet wheel C40059 Drive pawl C40060 Hammer knob C40061 Shear blade spring C40062 Detent ball C40063 Shear blade screw C40064 Shear blade A C40065 Shear blade B C40066 Pawl spring C40067 Windlass shaft C40068 Spring C40070 Bolt and nut C40071 Handle grip B C40073 Handle grip A www.BAND-IT-IDEX.com Page 2 of 2 Document # P40050 Rev. D © Copyright BAND-IT-IDEX, Inc. 2008 All rights reserved
