Download C10A / C30A Controller Cable Splitter Kit Installation Manual

Please read and understand instructions before attempting installation
C10A / C30A Controller Cable Splitter Kit
Installation Manual
Rev: 804042
Controller Cable Splitter Kit (RJ45SK)
1 x RJ45 Cable Splitter
2 x 2 Way Terminal block
INTRODUCTION
The Grifco Controller Cable Splitter Kit is used to connect two or more controllers to a single Maestro
Operator. Installation is quick and easy with only an additional controller cable (supplied with the
controller) and single wire being required to link the two controllers.
Note: Install the control station(s) where the door is visible.
D-M-ACG/013
Grifco Splitter Kit Users Manual – Standard Build
Please read and understand instructions before attempting installation
Note: The Splitter Kit can only be used in conjuction with standard Maestro
controls (C10A / C30A as shown below).
Grifco Splitter Kit Users Manual – Standard Build
2
Please read and understand instructions before attempting installation
Grifco Splitter Kit Users Manual – Standard Build
3
Please read and understand instructions before attempting installation
Grifco Splitter Kit Users Manual – Standard Build
4