Download Tail Gate Loader Installation Manual

APPENDIX 3 - SIDE ATTACHMENT FOR OTHER
TRAY TYPES*
* Required for trays with dropsides
If both the Standard Kit and Side Attachment Kit cannot be fitted to the tray, an
alternative side attachment will have to be developed and fitted for two reasons.
1. To fill the gap between the outer edge of the LycoLoader Tray Bracket and the
tray body’s existing dropside, and
2. To provide a method for securing the end of the tray body’s dropsides to the end
of the tray.
Figure 12 - Fabricated Attachment for to Secure Dropsides
This can be done by fabricating a side attachment plate to suit the tray body
concerned and then adding a suitable bracket to engage and retain the existing
latch on the end of the tray body’s dropside.
If the existing tray body’s latch cannot be adopted for use with the side attachment
plate, the existing latch may need to be removed and discarded and replaced with a
new latch arrangement such as the one supplied in the Side Attachment Kit, part
no. LL-Side Attach.