Download Installation Instructions

Mounting Instructions Propeller Type
Mounting Instructions Skew Blade Type
Check shaft coupling, motor shaft and radial shaft seal for damage
and slightly grease these parts before mounting.
Check shaft coupling, motor shaft and radial shaft seal for damage
and slightly grease these parts before mounting.
Mounting sequence according to the numbering 1 ... 4
in the direction of the arrows assigned to the numbers.
Mounting sequence according to the numbering 1 ... 5
in the direction of the arrows assigned to the numbers.
Va
ria
nt
I
Va
ria
II
nt
Va
4
2
III
Va
2
I
Va
ria
II
nt
Va
ria
nt
Apply slight force to push protective sleeve
next to the radial shaft seal.
4
Screw mixing blade onto the shaft end.
III
Va
2
4
2
4
Direction of
rotation
IV
Check adjusting spring for correct seat, before inserting
the mixing shaft into the gear.
Insert mixing shaft into the gear and firmly tighten it.
Push protective flange until it touches the gear flange.
2
2
ri
t
an
Slide protective flange onto the upper mixing shaft end.
1
Slide mixing shaft onto the motor shaft.
Align threaded pins to the grooves.
Thighten threaded pins.
Push protective flange until it touches the motor flange.
3
4
ria
nt
Slide protective flange onto the shaft coupling.
Make sure that the threaded pins do not jut out.
1
2
ria
nt
3
Apply slight force to push protective sleeve next to the
radial seal.
4
4
Check adjusting spring for correct seat, before sliding on
the mixing blade.
Slide mixing blade onto the lower shaft end and fasten it
by the nut.
5
5
Screw on the protective cover.
M8 ............... approx. 15 Nm
M10; M12 .... approx. 20 Nm
M16 ............. approx. 30 Nm
Motor flange
Shaft coupling
2
Groove
Groove
Direction of
rotation
upper mixing
shaft end
1
Threaded
pins
2
Gear flange
Adjusting
spring
Protective
flange
Radial shaft
seal
1
Mixing shaft
Protective
flange
Mixing shaft
3
Adjusting
springr
lower mixing
shaft end
Protective
sleeve for
coupling
4
I
II
Nut M16
approx. 60 Nm
Mixing blade
III
3
Radial shaft
seal
4
Mixing blade
Shaft end M 16
8
Protective
sleeve for
coupling
I
II
III
5
Protective cover
(with O-Ring)
IV
9