Download INSTALLATION MANUAL

Automatic Systems
3.7.3.
--
Loosen the four expansion bolts inside the front and rear end sections, at the bottom of the
housing.
--
Remove the two fixing brackets from the turnstile.
Note:
--
3.8.
•
Removing the unit
Either remove, or cut off floor fixing expansion bolts and make good the floor
surface, protruding fixings are a dangerous risk to the health and safety of persons
using the area.
Using manual handling or fork-lift truck remove the tripod turnstile to safe or its new location
for installation.
Scrapping the equipment
When the equipment is withdrawn from use, proceed with the dismantling procedure as
described in paragraph [3.7. Temporary dismantling]. Ensure that the various components of the
equipment (metals, electrical components, plastics, etc.) are handled, recycled, or disposed of in
the appropriate method, to comply with regulations and codes of practice in the country where the
unit is to be scrapped.
 Automatic Systems TR450-GB
YD-XX
MQ-1302
31/08/97
Installation TR450
2-1105GB
Rev.: A
p. 13/12