Download INSTALLATION MANUAL - ECR

Transcript
Indoor Unit Installation
1.
Installing the mounting plate
•Themountingplateshouldbeinstalledonawallwhichcansupporttheweightoftheindoorunit.
1)Temporarilysecurethemountingplatetothewall,makesurethatthepaneliscompletelylevel,andmarktheboring
pointsonthewall.
2)Securethemountingplatetothewallwithscrews.
Recommended mounting plate retention spots and dimensions
Recommended mounting plate
retention spots (5 spots in all)
209
241
191.5
Use tape measure
as shown.
Position the end of
a tape measure at .
48
298
250
50
75.5
Place a leveler
on raised tab.
48
50
66
150
176
384
106
344
Throughthe-wall
hole ϕ65mm
900
Keep here the piece cut out
from the unit for piping
Liquid pipe end
* The removed pipe port cover can be
kept in the mounting plate pocket.
Gas pipe end
Drain hose position
unit: mm
Removed pipe
port cover
A Mounting plate
2.
Boring a wall hole and installing wall embedded pipe
•Forwallscontainingmetalframeormetalboard,besuretouseawall
embeddedpipeandwallcoverinthefeed-throughholetopreventpossible
heat,electricalshock,orfire.
•Besuretocaulkthegapsaroundthepipeswithcaulkingmaterialtoprevent
waterleakage.
1)Boreafeed-throughholeof65mminthewallsoithasadownslopetowardtheoutside.
2)Insertawallpipeintothehole.
3)Insertawallcoverintowallpipe.
4)Aftercompletingrefrigerantpiping,wiring,anddrainpiping,caulkpipe
holegapwithputty.
3.
Inside
Wall embedded pipe
(field supply)
Outside
Caulking
ϕ65
Wall hole cover
(field supply)
Wall embedded pipe
(field supply)
Installing the indoor unit
•Inthecaseofbendingorcuringrefrigerantpipes,keepthefollowing
precautionsinmind.
Abnormalsoundmaybegeneratedifimproperworkisconducted.
1)Donotstronglypresstherefrigerantpipesontothebottomframe.
2)Donotstronglypresstherefrigerantpipesonthefrontgrille,either.
1)
2)
5
01_EN_3P320971-1B.indd 5
■English
12/10/2012 4:10:48 PM