Download LogWare II Real-Time Data Acquisition Software User's Guide

User’s Guide
9.12
Thermocouple Type Polynomial Settings dialog
The Thermocouple Type Polynomial Settings dialog allows the standard thermocouple type and the C0, C1, C2 and C3 coefficients to be entered.
Figure 184 Thermocouple Type Polynomial Settings dialog
If the Thermocouple Type coefficients were read in from the thermometer, the
boxes are filled with the current coefficient values.
The Thermocouple Type drop-down list allows the standard thermocouple type
to be selected. Thermocouple types include: B, C, E, J, K, L, M, N, R, S, T and
U. The choices in the list may be limited depending on the thermocouple types
supported by the thermometer being used.
Enter the values for all thermocouple polynomial coefficients from the Report
of Calibration. If any coefficients are not used, leave the boxes blank or set the
values to 0.0. The actual number of boxes displayed depends on the thermometer being used.
Click the Open button to display the Windows® Open dialog to open a previously saved configuration file which contains Thermocouple Type Polynomial
coefficients. Click the Save As button to display the Windows® Save As dialog
to save the current Thermocouple Type Polynomial coefficients to a configuration file.
Click the OK button to accept the current coefficients and close this dialog.
254