1
Download Concept HDL User Guide
Transcript
Concept HDL User Guide Cross-Referencing Your Design ■ Deleting Cross References on page 478 Cross-Referencing the Design To cross-reference a design, you need to perform the following steps: 1. Ensure that the librarian has made the necessary changes as mentioned in Placeholder Support on page 495. 2. Make sure that you have added ports or offpage symbols to all signals that require cross annotation. This will ensure that cross-references assigned by CRefer will move along with ports allowing for predictable placement in the schematic. 3. Open the schematic and perform the hier_write operation (File > Save Hierarchy) on the schematic of the root drawing. This operation will assign the PATH property to all the offpage symbols. 4. Close the schematic by selecting File > Exit in Concept HDL. 5. cross-reference the design. After the design is cross-referenced, you may open Concept HDL and view cross references. You will see that CRefer has made annotations for the entire design. CRefer has also substituted the variable values for all custom text that includes CRefer-specific custom variables. The flow-chart in the Cross Referencing Flow figure on page 470 summarizes the main crossreferencing steps: January 2002 469 Product Version 14.2
