Download TRT800 Installation

Installation Manual TRT800
Doc.-Nr: 03.2101.010.12e
Filser Electronic GmbH
3.9.
TEST MODE Page
To enable the TEST MODE Page press the “MODE” button until STBY is
displayed in the Mode Status.
While pressing the button “FID” (upper right) a number will start to count
up once per second. The Unit will enable the TEST MODE when number
7 appears and the button is released.
In this mode all transponder functions are still active except that errors
will not result in changing the mode to STBY. The error codes for
receiver signal quality (Sn) will now be displayed. This mode is used for
troubleshooting.
Squitter flag:
a= aquisition, p=position
v=velocity, i=identity
Reply flag
A=allcal, C=A/C
R=S-mode
If dot
Aircraft interface on
P= ADS-B-Position input,
A= Interface and init COM-B
E= Event driven squitter
T= TRA (BDS 07)
ON
OFF
FID
...X
X...
A. Si
ACS
.X..
P
MODE
TM
24
Fl0100
G
IDENT
Mode Status:
STBY
A-S
ACS
FPG
MTL
ANT
DC
TRX
PLL
3.9.1. List of Error Codes
Dialogue error to FPGA
Problem with minimum trigger level
Mismatch at antenna
Warning for low voltage
To low output power
Receiver frequency error
Revision: 1.10
Page: 20 of 27
..X.
Testmode active
FPGA-Error code
Flight Level
Status GND/FLIGHT