Download SLM User Guide

9: Managed Devices
Icon
Connection
Buttons
Description
SLC Serial Connection: Enables the SLM to connect to
the managed device through an SLC serial port by secure
channel and to cause the managed device to start logging
to an SLC.
SLCs display the Secure Channel button. SCSs as well
as Other Lantronix and Non-Lantronix devices display the
SSH Connection button for the serial port.
Note: If logging is on, the Stop Logging button displays
instead of the Start Logging button, and vice versa.
Power connection: Enables the SLM to control power on
the managed device through an SLP port. Two power
connections are available.
Note: If the SLM detects that the power is on, then only
the Power Off and Cycle Power buttons display. If the
SLM detects that the power is off, only the Power On
button displays. If the state of the power connection is not
known, all buttons display (but you also get a message
letting you know that the state was not detectable).
Modem: Enables the SLM to connect to the managed
device through the telephone network.
Note: This button reads Connect when no session
has been established and during session
negotiation. Refresh the page after establishing a
session, and this button reads Disconnect. If you
click the Disconnect button, be sure to refresh the
page as the session may not have terminated when
the new page was rendered.
2. To identify the port or device on the device server to which the managed device is
connected, move the pointer over the icon.
3. To go directly to the port or device page, click the icon.
Creating Individual Managed Devices
The administrator and permitted users can create individual managed devices in the
following ways:
‹
From a port
‹
From a list of ports
‹
From a device
SecureLinx SLM User Guide
164