Download USER MANUAL

29
Figure 49
POWER
Pressing this key sets up laser power for desired depth and effect (see Figure 50). Other
conditions are the same as stated in SPEED.
Figure 50
DEL FILE
Pressing this key (see Figure 51)deletes current file that is saved in the memory buffer (see
Figure 52). Under “Single file” mode, if you want to start engraving or cutting a new file,
you must press this key to clear up the memory buffer.
Figure 51
Delete current file?
Sure: press again
No: ESC
Figure 52
Wait for two seconds, and then press DEL FILE again to delete the file. The LCD will
show the following message as Figure 53:
Now deleting current
file please wait
Figure 53
RED BEAM
Pressing this key turns the red beam on or off (see Figure 54).
Chapter 4 Operation