Download User Manual

User’s Manual for UP-6000 multi-parameter patient monitor
Instructions to User
Dear Users,
Thank you very much for purchasing our product. Please read the following very carefully before
using this equipment.
These instructions describe the operating procedures to be followed strictly. Failure to follow
these instructions can cause monitoring abnormality, equipment damage and personal injury.
The manufacturer is NOT responsible for the safety, reliability and performance issues and any
monitoring abnormality, personal injury and equipment damage due to user’s negligence of the
operation instructions. The manufacturer’s warranty service does not cover such faults.
 WARNING-PACEMAKER PATIENTS. Rate meters may continue to count the
pacemaker rate during occurrences of cardiac arrest or some arrhythmias. Do not
rely entirely upon rate meter ALARMS. Keep pacemaker patients under close
surveillance. See this manual for disclosure of the pacemaker pulse rejection
capability of this instrument.
 Monitoring a single person at a time.
 The monitor is defibrillator proof. Verify that the accessories can function safely
and normally and the monitor is grounded properly before conducting
defibrillation.
 Disconnect the monitor and sensors before MRI scanning. Use during MRI could
cause burns or adversely affect the MRI image or the monitor’s accuracy.
 If you have any doubt to the grounding layout and its performance, you must use
the built-in battery to power the monitor.
 All combinations of equipment must be in compliance with standard of IEC 60601-1-1 for
medical and electric system requirements.
 Check SpO 2 probe application site periodically (every 30 minutes) to determine
circulation, positioning and skin sensitivity.
 The SpO 2 measurement of this monitor may not work for all testees. If stable
readings cannot be obtained at any time, discontinue using.
 Do not immerse the monitor or its accessories in liquid to clean.
 Do not use accessories
manufacturer.
other
than
those
provided/recommended
by
the
 Each time the monitor is used, check the alarm limits to ensure that they are
appropriate for the patient being monitored.
 The monitor is intended only as an adjunct in patient assessment. It must be used
in conjunction with clinical signs and symptoms.
 When taking the measure of a pediatric or neonate’s (less than 10 years old) blood pressure, do
NOT operate in the adult mode. The high inflation pressure may cause lesion or even body
putrescence.
II