Download USER MANUAL - SatellitePhoneStore.com

Chapter 4: Using the interfaces
Additional interfaces
Using the EXPLORER™ Bluetooth Handset charger
Before connecting to the EXPLORER™ Bluetooth Handset charger interface
If you are using an EXPLORER Bluetooth Handset, you can recharge the handset using the DC
charger interface of the EXPLORER 300.
Use the charger cable supplied with the EXPLORER Bluetooth Handset.
For specifications on the charger interface, see EXPLORER™ Bluetooth Handset charger interface
on page 150.
Connecting to the EXPLORER™ Bluetooth Handset charger interface
Do as follows:
1.
Connect the EXPLORER 300 to power, either using the AC/DC adapter connected to a 100240 V AC electrical outlet, or the Car charger cable connected to the cigarette lighter
socket/12 V DC in a car.
Note
The Bluetooth handset charger cannot recharge the Bluetooth handset from the
EXPLORER 300 battery. The EXPLORER 300 must be connected to external power.
2. Connect the Bluetooth charger cable to the charging
connector on the EXPLORER 300.
The charging connector is located at the back of the
EXPLORER 300, and is marked DC OUT. Make sure
the connector is oriented correctly in relation to the
coding of the plastic insert.
3.
Connect the other end of the cable to your EXPLORER Bluetooth Handset.
If the EXPLORER 300 is connected to power, the battery of the Bluetooth Handset is now
recharged.
What’s next?
This chapter has described the basics of how to set up and use each interface.
The following chapter, Using the web interface, describes how to use the built-in web interface for
setting up and using the EXPLORER 300.
TT 98-123571-E
Additional interfaces
67