Download Operating Instructions Fire Alarm System EBL512

Panasonic Electric Works Fire & Security Technology Europe AB
MEW01002
Rev: Operating Instructions Fire alarm system EBL512, V2.5.x
FAULT: SSD, FBP xx, 1587-board x, CU xx
FBP=1826 / 1828
There is no SSD (Site Specific Data) downloaded to the unit or
something is wrong in the downloaded SSD.
FAULT: Supervised output x, CU xx
If the output is programmed for sounders (type 3 = alarm devices), it
is also indicated by LED "Fault / Disablements Alarm devices" (L13)
blinking.
If the output is programmed for fire brigade tx (type 4 = routing
equipment), it is also indicated by LED "Fault / Disablements Fire
brigade tx" (L15) blinking.
x=0 (S0): Short circuit/break on the connected cable/ equipment
and/or blown fuse F5 or F6, on the connection board.
x=1 (S1): Short circuit/break on the connected cable/ equipment
and/or blown fuse F7 or F8, on the connection board.
x=2 (S2): Short circuit/break on the connected cable/ equipment
x=3 (S3): Short circuit/break on the connected cable/ equipment
• Connected equipment might be "stolen".
• Resistor(s) missing or not correct value (see dwg. 512-42).
FAULT: Superv. output x tech.no. xxxxxx
If the output is programmed for sounders (type 3 = alarm devices), it
is also indicated by LED "Fault / Disablements Alarm devices" (L13)
blinking. If the output is programmed for fire brigade tx (type 4 =
routing equipment), it is also indicated by LED "Fault / Disablements
Fire brigade tx" (L15) blinking.
•
•
•
•
Check fuses F1–F8 on the output unit p.c.b.
Short circuit / break on the connected wires.
Wrong / no end of line resistor.
One or more connected units have been removed (stolen).
FAULT: Wire to exting. system, CU xx
Short circuit / cut-off on the wires from the 1583 German Fire Brigade
interface board, in control unit No. xx, to the connected extinguishing
system / equipment.
FAULT: Wrong type board x, loop x, CU xx
This is valid for the I/O Matrix board (4582) no. x, connected on
COM loop x in the control unit no. xx.
61