Download Operating Instructions VEGAPULS 69

6 Set up with the display and adjustment module
Read from sensor: Read data from sensor and store into the display
and adjustment module
Write into sensor: Store data from the display and adjustment module back to the sensor
The following data or settings for adjustment of the display and adjustment module are saved:
•
•
•
All data of the menu "Setup" and "Display"
The menu items "Reset,Date/Time" in the menu "Additional settings"
Theuser-programmablelinearizationcurve
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
power failure. From there, they can be written into one or more sensors or kept as backup for a possible electronics exchange.
Note:
Before saving the data in the sensor, a safety check is made if the
data match with the sensor. For this purpose the sensor type of the
source data as well as the target sensor are displayed. If the data do
not match, a failure message is outputted or the function is blocked.
The data are only saved after release.
47249-EN-140707
Additional settings - Scal- In the menu item "Scaling"youdefinethescalingvariableandthe
ing
scaling format for the indication of the level measured value for 0 %
and 100 % on the display, for example as volume in l.
Additional settings - Current output 1 and 2 (size)
In menu item "Current output, variable" you specify which measured
variable the current output refers to.
Additional settings Current output 1 and 2
(adjustment)
In menu item "Current output, adjustment" you can assign a respective measured value to the current output.
VEGAPULS 69 • 4 … 20 mA/HART - four-wire
47