Download MW100 Viewer Software User's Manual

3.2 Settings Related to Displaying Measured, Computed, and Thinned Data
• Multi-axes zone
All the specified Y-axis of the displayed waveforms are aligned horizontally. To hide
a Y-axis, clear the Y-axes check box on the General Display Settings window. The
display position is set using Zone on the General Display Settings window. Dragging
the channel bar to the waveform display area shows the Y-axis of the corresponding
channel. Dragging the Y-axis to the zone display area hides the Y-axis of the
corresponding channel.
Indicates the
specified Y-axis
1
2
3
Select multi-axes zone
Viewer
4
Turn OFF the Y-axis
display of Ch00002
5
The Y-axis of Ch00002 is not displayed.
Click the bar to move the specified Y-axis to the right end
App
Grid Display
Select the grid type.
When this is selected
When this is selected
When this is selected
Trip Point
You can display a trip line to indicate a particular value of interest (trip point) in the
waveform display area. Two trip points (trip 1 is red, trip 2 is blue) can be set on each
waveform using the Trip 1 and Trip 2 settings on the General Display Settings window.
The trip line of the waveform corresponding to the right-most Y-axis is shown in the
waveform display area.
Trip 1 value
Trip 2 value
Trip line
Trip 1 value*
Turn ON the trip line display
Trip 2 value*
* Can be moved
by dragging
IM MW180-01E
3-9
Index