1
Download User Guide - Viglen
Transcript
VGA Enable/Disable JP1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table below for jumper settings. Watch Dog Enable/Disable Use JP2 to enable or disable the Watch Dog feature. The default position is open to disable it. When enabled, Watch Dog can reboot your PC if an application is "hung up" or the system goes down. See the table below for jumper settings. System Bus Speed JP3 allows you to select the system (front side) bus speed to 400 MHz, 533 MHz or Auto. The speed you select must conform to that of your processor(s). "Auto" is the default setting and will allow BIOS to determine and set the system bus speed. See the table below for jumper settings. Viglen SX235-L User Guide - MA-SX235L-0A-01 47
