Download Assembler/Linker/Librarian User's Guide

Assembler/Linker/Librarian User’s Guide
MPLAB IDE SETUP
Once MPLAB IDE is installed on your PC, check the settings below to ensure that the
language tools are properly recognized under MPLAB IDE.
1. From the MPLAB IDE menu bar, select Project>Set Language Tool Locations to
open a dialog to set/check language tool executable location.
FIGURE 1:
SET LANGUAGE TOOL LOCATIONS
2. In the dialog, under “Registered Tools”, select “Microchip MPASM Toolsuite”.
Click the “+” to expand.
3. Select “Executables”. Click the “+” to expand.
4. Select “MPASM Assembler (mpasmwin.exe)”. Under “Location”, a path to the
executable file should be displayed. If no path is displayed, enter one or browse
to the location of this file. The default location is listed in “MPLAB IDE and Tools
Installation”.
5. Select “MPLINK Object Linker (mplink.exe)”. Under “Location”, a path to the
executable file should be displayed. If no path is displayed, enter one or browse
to the location of this file. The default location is listed in “MPLAB IDE and Tools
Installation”.
6. Select “MPLIB Object Librarian (mplib.exe)”. Under “Location”, a path to the
executable file should be displayed. If no path is displayed, enter one or browse
to the location of this file. The default location is listed in “MPLAB IDE and Tools
Installation”.
7. Click OK.
DS33014J-page 10
© 2005 Microchip Technology Inc.