Download Installation and Operating Instructions

Ivory II
the elements will be automatically restored to the
previous setting at the time of interruption.
Fig.37
Safety cut-out
The unit is fitted with a non-resettable thermal
cut-out safety device. In the event of abnormal
operation which could cause unsafe temperatures
within the unit, the device will disconnect the
heating elements. It will require a visit from a
qualified engineer to determine the nature of the
fault and replace the safety device, once the unit
has been repaired.
ADJUSTING THE SHOWERHEAD
Five showerhead patterns are available (as shown
in fig.37).Adjustment is by turning the bezel on
the showerhead in either direction until the
desired pattern is obtained.
CLEANING
Do not use abrasive or solvent cleaning
fluids. The shower unit, riser rail, hose, etc.
should be cleaned using a soft cloth and
warm water.
It is advised before cleaning, to turn the isolation
switch off, thus avoiding the shower being
accidentally switched on.
IT IS IMPORTANT TO KEEP THE SHOWERHEAD
CLEAN TO MAINTAIN THE PERFORMANCE OF THE
SHOWER. The hardness of the water will
determine the frequency of cleaning. For example,
if the shower is used every day in a very hard
water area, it may be necessary to clean the
showerhead on a weekly basis.
Showerhead removal procedure
Remove the showerhead from flexible hose.
Remove the spray cartridge by locating the spray
key provided into the spray cartridge recesses and
unscrew anti-clockwise (fig.38).
Remove the two small black ‘O’ ring seals from
the rear of the spray cartridge (fig.39). Rinse the
‘O’ rings clean.
Scrub the spray cartridge with a small stiff bristle
brush (not wire bristles) to remove limescale
deposits (fig.40).
Pay particular attention to exterior grooves on the
spray cartridge. DO NOT use a pin or similar to
poke the holes otherwise, the efficiency of the
shower spray will be impaired.
Fig.38
17
Fig.39